Schrader EZ-Sensor™ Quick Start Guide

Schrader EZ-Sensor™ is a blank, programmable sensor that can have the sensor ID and protocol changed.

Download Quick Start GuideDownload Quick Start Guide

ITEMS INCLUDE

  1. SD Card with software loaded
  2. Quick Start Guide
  3. In-Depth User Guide
  4. EZ-Sensor™ Fixture
  5. Training Video CD

 

How to Update Via SD CardHOW TO UPDATE VIA SD CARD:

  1. Remove rubber boot from your tool
  2. With tool off, insert new SD card
  3. Press and Hold the ENTER key
  4. Press the ON key
  5. Release the ENTER and ON keys
  6. Press TEST to begin
  7. The tool will proceed to update
  8. The tool will power off when update is complete

 

Schrader® Snap-In Stem

Schrader® Snap-In Stem

Schrader® Clamp-In Stem

Schrader® Clamp-On Stem

PROPER TOOL POSITIONING:

Programming in Fixture Programming in Fixture

  • Using the fixture is the recommended programming method
  • Insert Tool into EZ-Sensor™ fixture
  • Insert EZ-Sensor™ into fixture
  • Follow procedure detailed below, then press Enter Button to start programming
  • Wait for process to complete and listen 
    for the audible beeping

Reading the Wheel/TireReading the Wheel/Tire

  • The tool position for the EZ Sensor is the same as for other sensors, as shown